Arduino Due Bass, Drum & Lead Sequencer

Rotary Encoder with Push-Button

Rotary Potentiometer, 10 kohm

3.5TFT Touch Display

Jumper wires (generic)

Micro SD Card

MP3 Arduino Shield - VS1003/1053

Arduino Due

<h3 >BassDrumLeadComputer</h3>A simple sequencer for Arduino Due with 3.5&#34; 8-bit tft-display(e.g.MCUfriends) and vs1053.Needed libraries:<pre ><code >Adafruit_GFX, MCUFRIEND_kbv, Scheduler, SDfat</code></pre>Install these libraries from the library manager in the Arduino IDE.Now we must configure some on the SdFat libray. Edit the SdFatConfig.h, and change<pre ><code >#define SPI_DRIVER_SELECT 0</code></pre>to<pre ><code >#define SPI_DRIVER_SELECT 2</code></pre><h3 ></h3><h3 >Wiring</h3>for the vs1053:<pre ><code >XCS to 46 XDCS to 48 DREQ to 50 XRST to 52 MOSI to A.26 MISO to A.25 SCK to A.27 5V to 3.3V</code></pre>for the rotary encoders:<pre ><code >all GNDs to GND all + to 3.3 volts SW from encoder1 to 23 (drums: vol, delay, pan) CLK from encoder1 to 22 DT from encoder1 to 24 SW from encoder2 to 25 (bass sound: vol, delay, pan) CLK from encoder2 to 26 DT from encoder2 to 28 SW from encoder3 to 27 (lead sound: vol, delay, pan) CLK from encoder3 to 30 DT from encoder3 to 32</code></pre>the potis:<pre ><code >one outer pin from all potis to gnd the other outer pin to 3.3V and the middle pins to: poti 1 to A8 (Master Vol control left) poti 2 to A9 (Master Vol control right) poti 3 to A10 (sets global reverb decay) poti 4 to A11 (bend range)</code></pre><h3 ></h3>