Telemetry 2.4 Mhz radio connection between 2 Arduino's

1#include <SPI.h>
2#include <nRF24L01.h>
3#include <RF24.h>
4
5RF24  radio(9, 10); // CE, CSN
6const byte address[6] = "00001";
7
8void setup()  {
9  Serial.begin(9600);
10  while(!Serial);                      // wait until  monitor is on
11
12  radio.begin();
13  radio.openReadingPipe(0, address);   //Setting  the address at which we will receive the data
14  radio.setPALevel(RF24_PA_MIN);       //You can set this as minimum or maximum depending on the distance between  the transmitter and receiver.
15  radio.startListening();              //This sets  the module as receiver
16
17  Serial.println("Receiver active");
18}
19
20void  loop()
21{
22  if (radio.available())               //Looking for the data.
23  {
24    char text[32] = "";                //Saving the incoming data
25    radio.read(&text,  sizeof(text));   //Reading the data
26    if (text[0] != 0) {
27      Serial.println(text);
28    }
29  }
30  delay(5);
31}

1#include <SPI.h>
2#include <nRF24L01.h>
3#include <RF24.h>
4
5RF24   radio(9, 10); // CE, CSN
6const byte address[6] = "00001";     //Byte of array   representing the address. This is the address where we will send the data. This   should be same on the receiving side.
7
8void setup() {
9  radio.begin();                   //Starting the Wireless communication
10  radio.openWritingPipe(address);   //Setting the address where we will send the data
11  radio.setPALevel(RF24_PA_MIN);   //You can set it as minimum or maximum depending on the distance between the transmitter   and receiver.
12  radio.stopListening();          //This sets the module as transmitter
13}
14
15void   loop()
16{
17  const char text[] = "Test text to send";
18  radio.write(&text,   sizeof(text));                  //Sending the message to receiver
19  delay(1000);
20}
21

1#include <SPI.h>
2#include <nRF24L01.h>
3#include <RF24.h>
4
5RF24  radio(9, 10); // CE, CSN
6const byte address[6] = "00001";     //Byte of array  representing the address. This is the address where we will send the data. This  should be same on the receiving side.
7
8void setup() {
9  radio.begin();                  //Starting the Wireless communication
10  radio.openWritingPipe(address);  //Setting the address where we will send the data
11  radio.setPALevel(RF24_PA_MIN);  //You can set it as minimum or maximum depending on the distance between the transmitter  and receiver.
12  radio.stopListening();          //This sets the module as transmitter
13}
14
15void  loop()
16{
17  const char text[] = "Test text to send";
18  radio.write(&text,  sizeof(text));                  //Sending the message to receiver
19  delay(1000);
20}
21