Getting started with Blynk

1/*
2 * Starting Blynk code.
3 * This code will connect to the Blynk  project
4 * Circuit: LED connected to digital pin 2, and a 220 ohm resistor to  GND
5 * Blynk project setup: Button widget (swipe right to left, select button,tap  * button while code is paused (play button at top,) select PIN, then select   *  D2)
6 * When you press the button, the LED should turn on
7 */
8
9
10#define  BLYNK_PRINT Serial // debug output
11
12#include <SPI.h>                  // necessary  libraries
13#include <WiFiNINA.h>
14#include <BlynkSimpleWiFiNINA.h>
15
16char  auth = "Your auth token (emailed to you when you create a project)";
17char ssid  = "Your network SSID";
18char pass = "Your network password"
19
20void setup(){
21  Serial.begin(9600); // debug output (Serial monitor)
22  Blynk.begin(auth, ssid,  pass);
23}
24
25void loop(){
26  Blynk.run(); // handle Blynk
27}