Arduino Ohm Meter

Resistor 100 ohm

Resistor 1k ohm

Processing3

Resistor 10k ohm

Arduino Uno Rev3

One of the easiest project that can be achieved with an Arduino and a few resistors it to make an ohm metter. With a well known values of resistance you can measure another one by voltage divider principle.So far so good, but you are limited by this reference value. You can't measure from 0.1 Ohm to 1 MOhm with a reference of 1 kOhm. First, the ratio from voltage divider will be so small that ADC will read noise or will be near one that means ADC will saturate at maximum value that can read so, it will display wrong value.Therefore, a simple way to increase the range of measurements is to add different reference resistors and then to switch between them in order to find value of unknown resistor. You don't want to wire and replace references always. Thus, a commanded switch can help for this step. With SN74HC4066 you can switch between 4 values.Reference resistor are chosen with decade interval: 100 ohm, 1kohm, 10kohm and 100kohm. Datasheet of quad analog switch is found <a href="http://www.ti.com/lit/ds/symlink/sn74hc4066.pdf">here</a>. Unknown resistor is place between purple wire(in schematic) and ground.Now, the code for switching and reading is easy. For a detailed description you can visit this <a href="http://explorelectronics.com/?p=190">post.</a>The final measurement is displayed by Processing interface which include 4 buttons for switching between the 4 references.In a nutshell is a easy project in order to understand basic electronic principles.

Arduino Ohm Meter

Measure the unknown resistor with a simple configuration!