A page turner for sheet music. Never pause to flip the page again!

1#include <Servo.h>
2
3Servo myservo;  // create servo object to control a servo
4
5int pos = 0;    // variable to store the servo position
6
7void setup() {
8  myservo.attach(9);  // attaches the servo on pin 9 to the servo object
9  pinMode(2, INPUT_PULLUP); // pin 2 is connected to the foot switch
10}
11
12void loop() {
13  if (digitalRead (2)==HIGH){ //If the foot switch is pressed (set HIGH instead of LOW if pressing the foot switch opnes the circuit)
14    for (pos = 170; pos >= 10; pos -= 1) { // goes from 170 degrees to 10 degrees. You may need to adjust the angles to your specific setup
15      myservo.write(pos);              // tell servo to go to position in variable 'pos'
16      delay(5);                       // waits 5 ms for the servo to reach the position. You can adjust this value to turn pages faster or slower
17    }
18    for (pos = 10; pos <= 170; pos += 1) { // goes from 10 degrees to 170 degrees
19    // in steps of 1 degree
20    myservo.write(pos);              // tell servo to go to position in variable 'pos'
21    delay(5);                       // waits 5 ms for the servo to reach the position
22    }
23  }
24}