XBee Arduino Interfacing

1#include <SoftwareSerial.h>
2SoftwareSerial XBee(2, 3);
3
4void   setup()
5{
6  XBee.begin(9600);
7  Serial.begin(9600);
8}
9
10void loop()
11{
12   if (Serial.available())
13  { 
14    XBee.write(Serial.read());
15      }
16   if (XBee.available())
17  { 
18    Serial.write(XBee.read());
19      }
20}
21

#include <SoftwareSerial.h>
SoftwareSerial XBee(2, 3);

void   setup()
{
  XBee.begin(9600);
  Serial.begin(9600);
}

void loop()
{
   if (Serial.available())
  { 
    XBee.write(Serial.read());
      }
   if (XBee.available())
  { 
    Serial.write(XBee.read());
      }
}

XbeeArduino.ino

arduino

1#include <SoftwareSerial.h>
2SoftwareSerial XBee(2, 3);
3
4void  setup()
5{
6  XBee.begin(9600);
7  Serial.begin(9600);
8}
9
10void loop()
11{
12  if (Serial.available())
13  { 
14    XBee.write(Serial.read());
15      }
16  if (XBee.available())
17  { 
18    Serial.write(XBee.read());
19      }
20}
21

#include <SoftwareSerial.h>
SoftwareSerial XBee(2, 3);

void  setup()
{
  XBee.begin(9600);
  Serial.begin(9600);
}

void loop()
{
  if (Serial.available())
  { 
    XBee.write(Serial.read());
      }
  if (XBee.available())
  { 
    Serial.write(XBee.read());
      }
}

Downloadable files

After Uploading The Code

1/ Open the Arduino's Serial Monitor. Make sure the baud rate is set to 9600. 2/ On your X-CTU click on console mode. 3/ Type something in the console view, it should show up on the Serial Monitor. 4/Now try typing something into the Arduino's Serial Monitor , then press send ,it should show up in the console view.

After Uploading The Code

The configuration of your XBee.

Channel = C PAN ID = 3332 DH = 0 DL = 0 MY = 0

The configuration of your XBee.

Proteus Circuit Diagram

Gnd Xbee - Gnd Arduino Vcc Xbee - 3.3V Arduino Tx - Rx pin D0 Arduino Rx - Tx pin D1 Arduino

Proteus Circuit Diagram

Add Your Xbee

Assembling Hardware

After Uploading The Code

Assembling Hardware

Installing X-CTU

https://www.digi.com/resources/documentation/digidocs/90001526/tasks/t_download_and_install_xctu.htm

Installing X-CTU

The configuration of your XBee.

Channel = C PAN ID = 3332 DH = 0 DL = 0 MY = 0

The configuration of your XBee.

Proteus Circuit Diagram

Gnd Xbee - Gnd Arduino Vcc Xbee - 3.3V Arduino Tx - Rx pin D0 Arduino Rx - Tx pin D1 Arduino

Proteus Circuit Diagram

Add Your Xbee

Documentation

Components Required

Comments

Only logged in users can leave comments

Fouad_Roboticist

0 Followers

•

0 Projects

Intro