Audio Input

1M resistor

2.2k resistor

Arduino Uno Rev3

10k resistor

Breadboard 830 points with Wire Kit

Capacitor 10 pF

Electret microphone

TLV2451C

Capacitor 4.7 µF

<h3 >1. How does it work? </h3>Since the signal of the microphone is too little to drive directly the analog input, we need to amplify it. Furthermore a good read of the analog input can be done if the input signal is between 0 and 5V so we also need to offset it. This can be done through an operational amplifier.  In particular we will use an <a href="http://en.wikipedia.org/wiki/Operational_amplifier#Inverting_amplifier">inverting amplifier</a> because is simple and an audio signal is not affected by a rotation of 180°.<h3 >2. Schematic</h3>This is the resulting schematic.<figure><img src=https://projects.arduinocontent.cc/6d479854-024b-4430-aed2-8b941e8e590e.png /><figcaption> </figcaption></figure><h3 >3. The code</h3>Now we can simply read the analog input in this way. Take note that if there isn't an audio signal the read will be about 512 because to have an audio signal between 0 and 5V we need an offset of 2.5V. Little variations are caused by the noise.<pre ><code >/*Read the analog input of a microphone Author: Arturo Guadalupi */ int micIN= A0; int audioVal = 0; void setup() { Serial.begin(9600); } void loop() { audioVal = analogRead(micIN); Serial.println(audioVal); delay(600); } </code></pre>

Schematic 1

Code snippet #1

Audio Input

This lesson aims to show how to interface an electret microphone with the analog input.