Arduino MKR GSM 1400 and DTMF

Arduino IDE

Arduino MKR GSM 1400

Resistor 10k ohm

Jumper wires (generic)

3.7 V LiPo Battery

NeoPixel Ring: WS2812 5050 RGB LED

Arduino Web Editor

2N7000

Breadboard (generic)

<p ><strong >Note: This tutorial could be outdated, please go </strong><strong ><a href="https://docs.arduino.cc/tutorials/projects/arduino-mkr-gsm-1400-and-dtmf">here</a></strong><strong > for a more current version.</strong></p><h3 >Introduction</h3><p >Like every phone, the GSM module on your Arduino MKR GSM 1400 can recognize DTMF tones. These are the tones that you can hear whenever you press a key on your phone's keyboard during a call. </p><h3 >How It Works</h3><p >The operating principle of this tutorial is very simple: every time a phone call is received, the board answers the call and waits for a DTMF tone. When the tone is pressed, the board parses it, prints it on the serial monitor, and changes the LEDs color according to the pressed button.</p><h3 >Hardware Connections</h3><p >As you can see from the breadboard layout, a transistor is present between the Arduino board and the NeoPixel input. This is placed since the MKR GSM 1400 operates at 3.3V while the NeoPixel works at 5V. The transistor is used as a voltage translator. In the layout, there is also  a single NeoPixel placed instead of the ring just for the sake of simplicity.</p><h3 >Setup</h3><p >The setup to use this code is very simple. You just have to:</p><ul ><li >Plug the antenna into the board</li></ul><ul ><li >Plug a micro SIM card into your board</li></ul><ul ><li >Connect the LEDs as shown in the scheme</li></ul><ul ><li >Plug the battery into the board</li></ul><ul ><li >Plug the micro USB cable and connect it to your PC</li></ul><ul ><li >Load the code on the board using the Arduino Java or Web IDE</li></ul><ul ><li >Open the serial monitor</li></ul><ul ><li >Call the board and enjoy pressing buttons on your keyboard!</li></ul><h3 >See Also</h3><p ><span >This example is based on the </span><a href="https://www.arduino.cc/en/Reference/MKRGSM">Arduino MKR GSM</a><span > library. </span></p>

HW connections

Arduino MKR GSM 1400 and DTMF

This tutorial shows how to use the Arduino MKR GSM 1400's DTMF feature to have a direct interaction with your phone.